CONTROL SYSTEMS
10) Install the rear exhaust pipe and muffler.
Non-turbo model with OBD
<Ref. to EX-11, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX-12, INSTALLATION, Muffler.>
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-13, INSTALLATION, Rear
Exhaust Pipe.>, <Ref. to EX(w/oOBD)-14, IN-
STALLATION, Muffler.>
Turbo model
<Ref. to EX(TURBO)-13, INSTALLATION, Rear
Exhaust Pipe.>, <Ref. to EX(TURBO)-14, INSTAL-
LATION, Muffler.>
11) Lower the vehicle.
12) Install the boot plate to body.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
13) Install the console box. <Ref. to EI-40, INSTAL-
LATION, Console Box.>
C: DISASSEMBLY
1) Disassemble the lock wire.
(A) Lock wire
(B) Stay
2) Remove the rod from lever.
(A) Rod
(B) Lever
(C) Stay
MT GEAR SHIFT LEVER
3) Remove the snap ring from bush B, then discon-
nect the stay.
4) Remove the boot from gear shift lever.
5) Remove the bush and cushion rubber from stay.
B3M0617C
6) Remove the O-ring, then disconnect the bush B.
B3M1828A
CS-14
(A) Snap ring
(B) Bush B
(C) Boot
(A) Bush
(B) Stay
(C) Cushion rubber
(A) O-ring
(B) O-ring
(C) Bush B
B3M0619B
B3M0830D
B3M0620C