Subaru 2002 IMPREZA Service Manual page 2059

5) Connect the rear stabilizer to rear lateral link.
CAUTION:
Use a new self-locking nut.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb)
6) Connect the parking brake cable to parking
brake.
7) Clean the brake pipe connection. Using a flare-
nut wrench, connect the brake pipe to wheel cylin-
der.
8) Connect the rear ABS sensor to back plate (only
vehicle equipped with ABS).
(1) ABS sensor
9) Connect the parking brake cable to lever.
10) Install the brake drum on rear housing assem-
bly.
11) Bleed the air from brake system. <Ref. to BR-
55, REPLACEMENT, Brake Fluid.>
12) Adjust the parking brake lever stroke by turning
adjuster.
13) Move the brake lever back to apply brakes.
While depressing the brake pedal, tighten axle nut
using a socket wrench. Lock the axle nut after tight-
ening.
Tightening torque:
186 N·m (19 kgf-m, 137 ft-lb)
CAUTION:
• Use a new axle nut.
• Always tighten the axle nut before installing
wheel on the vehicle. If the wheel is installed
and comes in contact with ground when axle
nut is loose, wheel bearings may be damaged.
• Be sure to tighten the axle nut to specified
torque. Do not overtighten it as this may dam-
age the wheel bearing.
14) Install the wheel, and then tighten the wheel
nuts to specified torque.
Tightening torque:
88 N·m (9.0 kgf-m, 65 ft-lb)
REAR AXLE
C: DISASSEMBLY
1) Using the ST1 and ST2, remove the hub from
rear housing.
ST 927080000
ST 927420000
2) Remove the back plate from rear housing
3) Using a standard screwdriver, remove the outer
and inner oil seals.
CAUTION:
Use new oil seals.
4) Using a flat bladed screwdriver, remove the
H4M1139B
snap ring.
CAUTION:
Be careful not to damage the housing at remov-
al.
DS-29
DRIVE SHAFT SYSTEM
HUB STAND
HUB REMOVER
G4M0250
H4M1003