Subaru 2002 IMPREZA Service Manual page 1854

CLUTCH SYSTEM
C: CAUTION
• Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust or dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
• Be careful not to burn your hands, because each
part on the vehicle is hot after running.
• Use SUBARU genuine fluid, grease etc. or the
equivalent. Do not mix fluid, grease etc. with that of
another grade or from other manufacturers.
D: PREPARATION TOOL
1. SPECIAL TOOLS
ILLUSTRATION
B2M3853
B2M4112
GENERAL DESCRIPTION
TOOL NUMBER DESCRIPTION
498497100 CRANKSHAFT
STOPPER
499747100 CLUTCH DISC
GUIDE
CL-18
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or safety stands at the specified
points.
• Apply grease onto sliding or revolution surfaces
before installation.
• Before installing O-rings or snap rings, apply suf-
ficient amount of fluid to avoid damage and defor-
mation.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
• Keep fluid away from the vehicle body. If any flu-
id contacts the vehicle body, immediately flush the
area with water.
Used for stopping rotation of flywheel when loos-
ening tightening bolt, etc.
Used when installing clutch disc to flywheel.
REMARKS