Subaru 2002 IMPREZA Service Manual page 1782

MANUAL TRANSMISSION AND DIFFERENTIAL
2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Reverse check sleeve assembly uses an O-ring
which should not be scratched.
• Be careful not to break the adjustment shim
placed between reverse check sleeve assembly
and case.
REVERSE CHECK SLEEVE
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, check cam, return spring
and check spring onto reverse check sleeve.
NOTE:
Be sure the bent section of reverse check spring is
positioned in the groove in check cam.
B3M1384A
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate the cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With the cam held in that position, install the
plate onto reverse check sleeve and hold with snap
ring.
5) Position the O-ring in groove in sleeve.
MT-58
(A) Reverse check spring
(B) Reverse check cam
(C) Return spring (5th-Rev)
(D) Reverse accent shaft
(E) Return spring cap
(F) Return spring (1st-2nd)
(G) Reverse check sleeve
B3M1384A