Subaru 2002 IMPREZA Service Manual page 1790

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Tighten the seventeen bolts with bracket, clip,
etc. as shown in the figure.
NOTE:
• Insert the bolts from bottom and tighten the nuts
at top.
• Put the cases together so that the drive pinion
shim and input shaft holder shim are not caught up
in between.
• Confirm that the speedometer gear is meshed.
Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.1 ft-lb)
# # # # 10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
7) Tighten the ball bearing attachment bolts.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
TRANSMISSION CASE
8) Tighten the input shaft holder attaching bolts.
Tightening torque:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
9) Backlash adjustment of hypoid gear and preload
adjustment of roller bearing
NOTE:
Support the drive pinion assembly with ST.
ST 498427100
S3M0161A
10) Place the transmission with case left side fac-
ing downward and put ST1 on bearing cup.
S3M0099
MT-66
(A) Input shaft holder
(B) Input shaft
STOPPER
B3M2175A
B3M1362A