Subaru 2002 IMPREZA Service Manual page 1883

3) Depress and release the clutch pedal two to
three times to ensure that clutch pedal and release
fork operates smoothly. If the clutch pedal and re-
lease fork do not operate smoothly, bleed air from
the clutch hydraulic system. <Ref. to CL-38, Clutch
Fluid Air Bleeding.>
4) Measure the clutch pedal full stroke length again
to ensure that it is within specifications. If it is not,
repeat adjustment procedures again from the be-
ginning.
Specified clutch pedal full stroke:
130 — 135 mm (5.12 — 5.31 in)
5) Move the clevis pin to the left and then to the
right. It should move without resistance while it is
rattling. If resistance is felt, repeat adjustment pro-
cedures again from the beginning.
6) Push the release lever until operating cylinder
push rod retracts. Ensure that clutch fluid level in
reservoir tank increases. If the clutch fluid level in-
creases, hydraulic the clutch is properly adjusted; if
fluid level does not increase or push rod does not
retract, replace the master cylinder with a new
one.<Ref. to CL-31, Master Cylinder.>
(1) Push rod
(2) Release lever
(3) Operating cylinder
CLUTCH PEDAL
7) Push the release lever until operating cylinder
push rod retracts. Check that the clutch fluid level in
reservoir tank increases.
8) If the clutch fluid level increases, hydraulic clutch
play is correct.
9) If the clutch fluid level does not increase or push
rod does not retract, clutch pedal must be readjust-
ed.
10) Check the fluid level on the outside of the res-
ervoir tank. If the level is below "MIN", add clutch
fluid to bring it up to "MAX".
Recommended clutch fluid:
FMVSS No. 116, fresh DOT 3 or DOT 4 brake
fluid
B4M1191B
• 1.6 L MODEL
1) Disconnect the ground cable from battery.
2) Remove the air cleaner case and intake duct.
<Ref. to IN-6, REMOVAL, Air Cleaner Case.> and
<Ref. to IN-7, REMOVAL, Air Intake Duct.>
3) Remove the release lever return spring from le-
ver.
4) Loosen the lock nut.
CL-47
(1) Push rod
(2) Release lever
(3) Operating cylinder
(A) Max. level
(B) Min. level
(C) Reservoir tank
CLUTCH SYSTEM
B4M1191B
(C)
(A)
(B)
TR0478