Subaru 2002 IMPREZA Service Manual page 1575

B: INSTALLATION
1) Set the range select lever in "N" range.
2) Install the control valve and ground connectors.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A) Short bolts
(B) Long bolts
3) Connect all connectors.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
4) Attach the magnet at the specified position.
CONTROL VALVE BODY
5) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
B3M1037A 6) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B
B3M2263I
7) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
8) Pour ATF into the oil charge pipe.
Recommended fluid:
Dexron III type automatic transmission fluid
Fluid capacity:
Fill the same amount of fluid drained from
drain plug hole.
9) Check the level of ATF.
<Ref. to AT-9, Automatic Transmission Fluid.>
C: DISASSEMBLY
Refer to "AUTOMATIC TRANSMISSION" <Pub.
No. G0864ZE> a separate publication.
D: ASSEMBLY
Refer to "AUTOMATIC TRANSMISSION" <Pub.
No. G0864ZE> a separate publication.
E: INSPECTION
Refer to "AUTOMATIC TRANSMISSION" <Pub.
No. G0864ZE> a separate publication.
B3M1105
AT-39
AUTOMATIC TRANSMISSION
B3M1040
B3M2265