Subaru 2002 IMPREZA Service Manual page 1910

FRONT SUSPENSION
B: INSTALLATION
1) Install the strut mount at upper side of strut to
body, and then tighten with nuts.
Tightening torque:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
2) Position the aligning mark on camber adjust-
ment bolt with aligning mark on lower side of strut.
CAUTION:
• While holding the head of adjusting bolt,
tighten self-locking nut.
• Be sure to use a new self-locking nut.
Tightening torque:
175 N·m (17.8 kgf-m, 129 ft-lb)
3) Install the ABS sensor harness to strut.
Tightening torque:
33 N·m (3.4 kgf-m, 24.3 ft-lb)
4) Install the bolts which secure brake hose to strut.
Tightening torque:
33 N·m (3.4 kgf-m, 24.3 ft-lb)
5) Install the wheels.
NOTE:
Check the wheel alignment and adjust if necessary.
FRONT STRUT
C: DISASSEMBLY
1) Using a coil spring compressor, compress the
coil spring.
2) Using the ST, remove the self-locking nut.
ST 927760000
3) Remove the strut mount, upper spring seat and
rubber seat from strut.
4) Gradually decreasing the compression force,
and then remove the coil spring.
5) Remove the dust cover and helper spring.
FS-20
S4M0095
STRUT MOUNT SOCKET
S4M0096A