Subaru 2002 IMPREZA Service Manual page 1768

MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1. BACK-UP LIGHT SWITCH AND NEU-
TRAL POSITION SWITCH
1) Install the back-up light switch and neutral posi-
tion switch with harness.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Neutral switch
(B) Back-up light switch
2) Connect the connector of back-up light switch
and neutral position switch.
3) Install the air intake duct and cleaner case.
(Non-turbo model) <Ref. to IN-6, INSTALLATION,
Air Cleaner Case.> and <Ref. to IN-7, INSTALLA-
TION, Air Intake Duct.>
4) Install the intercooler. (Turbo model)
<Ref. to IN(TURBO)-11, INSTALLATION, Inter-
cooler.>
5) Connect the battery ground cable to battery.
2. HIGH-LOW SWITCH
1) Install the high-low switch.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
2) Install the high-low switch cable to clamp.
3) Connect the connector of high-low switch.
4) Install the air intake duct and cleaner case. <Ref.
to IN-6, INSTALLATION, Air Cleaner Case.> and
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
5) Connect the battery ground cable to battery.
SWITCHES AND HARNESS
C: INSPECTION
1. BACK-UP LIGHT SWITCH
Inspect the back-up light switch. <Ref. to LI-7, IN-
SPECTION, Back-up Light System.>
2. NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector of neutral position
switch.
3) Measure the resistance between neutral posi-
tion switch terminals.
Non-turbo model:
Turbo model:
B3M1372C
• Non-turbo MODEL
• Turbo MODEL
4) Replace defective parts.
MT-44
Gear shift position Terminal No.
Neutral position
1 and 2
Other positions
Gear shift position Terminal No.
Neutral position
1 and 3
Other positions
Specified resistance
Less than 1Ω
More than 1MΩ
Specified resistance
Less than 1Ω
More than 1MΩ
2 1
TR0100
2 1
4 3
TR0101