Subaru 2002 IMPREZA Service Manual page 2397

6) Using a standard screwdriver, remove the band
from boot.
(1) Band
7) Extend the rack approx. 40 mm (1.57 in) out. Un-
lock the lock wire at lock washer on each side of tie-
rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch the rack surface as oil
leaks may result.
(1) Lock washer
8) Using the ST, loosen the lock nut.
ST 926230000 SPANNER
STEERING GEARBOX [LHD MODEL]
S4M0145C
S4M0146C
S4M0147C
PS-35
POWER ASSISTED SYSTEM (POWER STEERING)
9) Tighten the adjusting screw until it no longer
tightens.
10) Using a wrench [32 mm (1.26 in) width across
flats] or adjustable wrench, remove the tie-rod.
CAUTION:
• Check the ball joint for free play, and tie-rod
for bends. Replace if necessary.
• Check the dust seals used with tie-rod end
ball joint for damage or deterioration. Replace if
necessary.
11) Loosen the adjusting screw, and then remove
the spring and sleeve.
CAUTION:
Replace the spring and/or sleeve if damaged.
12) Remove the two bolts securing valve assem-
bly.
S4M0148
S4M0149
S4M0154