MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
5) Using the ST1, ST2 and a press, remove the ball
bearing, synchro cone and baulk ring (Rev).
NOTE:
• Replace the sleeve and hub with new ones. Do
not attempt to disassemble because they must en-
gage at a specified point. If they should be disas-
sembled, mark engagement point on splines
beforehand.
• Do not reuse the ball bearing.
ST1 499757002
INSTALLER
ST2 498077400
SYNCHRO CONE REMOV-
ER
(A) Ball bearing
(B) Synchro cone
(C) Baulk ring
6) Using the ST1 and ST2, remove rest of the
parts.
NOTE:
Replace the sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at a specified point. If they should be disassem-
bled, mark engagement point on splines before-
hand.
ST1 899864100
ST2 899714110
B3M1365A
MT-69
MANUAL TRANSMISSION AND DIFFERENTIAL
REMOVER
REMOVER
B3M0835A