Subaru 2002 IMPREZA Service Manual page 2211

DIAGNOSTICS CHART WITH SUBARU SELECT MONITOR
Step
23 CHECK SHIELD CIRCUIT.
1)Connect all connectors.
2)Measure the resistance between shield con-
nector and chassis ground.
Connector & terminal
DTC 24 / LHD: (F45) No. 8 — Chassis
ground:
DTC 26 / LHD: (B99) No. 23 — Chassis
ground:
DTC 26 / RHD: (B99) No. 22 — Chassis
ground:
DTC 28 / LHD: (B99) No. 16 — Chassis
ground:
DTC 28 / RHD: (B99) No. 10 — Chassis
ground:
NOTE:
For the DTC 22 and 24: (RHD)
Go to step 24.
24 CHECK ABSCM&H/U.
1)Connect all connectors.
2)Erase the memory.
3)Perform the inspection mode.
4)Read out the DTC.
25 CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES (DTCs) APPEARANCE.
Check
Is the resistance less than 0.5
Ω?
Is the same DTC as in the cur-
rent diagnosis still being out-
put?
Are other DTCs being output? Proceed with the
ABS-113
ABS (DIAGNOSTICS)
Yes
Go to step 24. Repair the shield
harness.
Replace the Go to step 25.
ABSCM&H/U.
<Ref. to ABS-7,
ABS Control Mod-
ule and Hydraulic
Control Unit
(ABSCM&H/U).>
A temporary noise
diagnosis corre- interference.
sponding to DTC.
No