Subaru 2002 IMPREZA Service Manual page 1803

5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
NOTE:
Face the thrust washer in correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
B3M0553F
B3M0091D
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Install the bearing onto synchro cone.
8) Install the baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
NOTE:
• Use a new ball bearing.
• After press fitting, make sure the synchro cone
rotates freely.
ST 499757002
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
(A) Synchro cone stopper
(B) Snap ring
MT-79
INSTALLER
B3M1370A
B3M0435B