Subaru 2002 IMPREZA Service Manual page 2056

DRIVE SHAFT SYSTEM
7) If it is difficult to remove the brake drum, remove
the adjusting hole cover from back plate, and then
turn the adjusting screw using a slot-type screw-
driver until brake shoe separates from the drum.
(1) Back plate
(2) Wheel cylinder
(3) Adjuster ASSY pawls
(4) Adjusting lever
(5) Tightening direction
(6) Push
NOTE:
If the brake drum is difficult to remove, drive it out
by installing an 8-mm bolt into bolt hole in brake
drum.
8) Using a flare-nut wrench, disconnect the brake
pipe from wheel cylinder.
CAUTION:
Cover the open end of wheel cylinder to prevent
entry of foreign particles.
REAR AXLE
9) Disconnect the parking brake cable end.
S4M0369A
10) Disconnect the rear stabilizer from rear lateral
link.
11) Remove the bolts which secure trailing link as-
sembly to rear housing.
CAUTION:
Discard the old self-locking nut. Replace with a
new one.
12) Remove the bolts which secure lateral link as-
sembly to rear housing.
CAUTION:
Discard the old self-locking nut. Replace with a
G4M0243
new one.
G4M0244
DS-26
(1) Cable end
S4M0368A
S4M0109
S4M0110