Subaru 2002 IMPREZA Service Manual page 1814

MANUAL TRANSMISSION AND DIFFERENTIAL
7) After installing the key on driven shaft, install the
3rd-4th driven gear using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Align the groove in baulk ring with insert.
ST 499277200 INSTALLER
8) Install a set of roller bearings onto the driven
shaft using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
9) Position the woodruff key in groove on the rear
of driven shaft. Install the 5th driven gear onto drive
shaft using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
DRIVE PINION SHAFT ASSEMBLY
G3M0615
G3M0616
G3M0617
MT-90
10) Install the lock washer. Install the lock nut and
tighten to the specified torque using ST.
ST 499987300 SOCKET WRENCH (50)
Tightening torque:
265 N·m (27 kgf-m, 195 ft-lb)
NOTE:
• Stake the lock nut at two points.
• Using the spring balancer, check that starting
torque of roller bearing is 0.1 to 1.5 N (0.01 to 0.15
kgf, 0.02 to 0.33 ft).
11) Install the roller bearing onto drive pinion.
NOTE:
When installing the roller bearing, note its direc-
tions (front and rear) because the knock pin hole in
outer race is offset.
(A) Roller bearing
(B) Knock pin hole
G3M0618
B3M0079
B3M1661A