Subaru 2002 IMPREZA Service Manual page 1821

2) Remove the oil seal.
NOTE:
Do not reuse the oil seal. Prepare a new oil seal.
3) Remove either side of split pin and pin, and re-
move the claw.
ST 398527700 PULLER ASSY
(A) Claw
(B) Split pin
(C) Pin
4) Attach two claws to the outer race securely, and
set ST to side retainer.
ST 398527700 PULLER ASSY
NOTE:
• Attach notch portions of the two shafts securely
to side retainer.
• Restore the removed claws to original position,
and install the pin and split pin.
(A) Shaft
(B) Claw
FRONT DIFFERENTIAL ASSEMBLY
B3M2193
B3M2198A
B3M2194A
MT-97
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Remove the bearing outer race from side retain-
er.
ST 398527700 PULLER ASSY
NOTE:
• Fix the shaft of ST secure enough that it will not
loosen and fall from side retainer.
• When replacing the bearing outer race, replace it
with inner race as a set.
(A) Shaft
(B) Side retainer
D: ASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Install the bevel gear and bevel pinion together
with washers, and insert pinion shaft.
NOTE:
Face the chamfered side of washer toward gear.
(A) Bevel pinion
(B) Bevel gear
(C) Pinion shaft
B3M2195A
B3M0099D