Subaru 2002 IMPREZA Service Manual page 1762

MANUAL TRANSMISSION AND DIFFERENTIAL
12) Drive the spring pin into chamfered hole of
drive shaft.
NOTE:
Always use a new spring pin.
13) Install the ball joints of lower arm into knuckle
arm of housing, and tighten the installing bolts.
Tightening torque:
49 N·m (5.0 kgf-m, 36 ft-lb)
(A) Transverse link
(B) Ball joint
14) Install the stabilizer link from transverse link.
• Except sedan turbo MODEL
Tightening torque:
30 N·m (3.1 kgf-m, 22.1 ft-lb)
MANUAL TRANSMISSION ASSEMBLY
G2M0325
B2M3402A
TR0089
MT-38
• Sedan turbo MODEL
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
15) Install the gear shift rod and stay.
(1) Install the gear shift rod onto transmission.
(A) Stay
(B) Rod
(2) Install the stay onto transmission.
16) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
17) Install the heat shield cover. (If equipped)
18) Install the hanger bracket on right side of trans-
mission.
19) Install the rear exhaust pipe and muffler.
TR0090
B3M1824A
B2M0032