Subaru 2002 IMPREZA Service Manual page 2435

7. Pipe Assembly [LHD MODEL]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the jack-up
plate.
(1) Jack-up plate
3) Remove the one pipe joint at center of gearbox,
and then connect the vinyl hose to pipe and joint.
Discharge fluid by turning the steering wheel fully
clockwise and counterclockwise. Discharge fluid
similarly from the other pipe.
CAUTION:
Improper removal and installation of parts often
causes fluid leak trouble. To prevent this, clean
the surrounding portions before disassembly
and reassembly, and pay special attention to
keep dirt and other foreign matter from mating
surfaces.
(1) Pipe A
(2) Pipe B
PIPE ASSEMBLY [LHD MODEL]
S4M0380A
S4M0381A
PS-73
POWER ASSISTED SYSTEM (POWER STEERING)
4) Remove the clamp E from pipes C and D.
(1) Return hose
(2) Pressure hose
(3) Clamp E
(4) Pipe C
(5) Pipe D
5) Disconnect the pipes C and D from pipe (on the
gearbox side).
CAUTION:
• When disconnecting the pipes C and D, use
two wrenches to prevent deformities.
• Be careful to keep the pipe connections free
from foreign matter.
(1) Pipe C
(2) Pipe D
S4M0437A
S4M0382A G4M0101