Subaru 2002 IMPREZA Service Manual page 1576

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
17.Shift Solenoids, Duty Sole-
noids and ATF Temperature
Sensor
A: REMOVAL
1) Lift-up the vehicle.
2) Clean the transmission exterior.
3) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
4) Remove the oil pan.
5) Disconnect the solenoid and sensor connectors.
Remove the connectors from clip and disconnect
the connectors.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
6) Remove the solenoids, duty solenoids and ATF
temperature sensor.
1. TRANSFER DUTY SOLENOID AND
B3M1036C
TRANSFER VALVE BODY
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
4) Remove the intercooler. (Turbo model)
<Ref. to IN(TURBO)-10, REMOVAL, Intercooler.>
5) Remove the pitching stopper.
B2M2263J
6) Remove the front exhaust pipe with center ex-
haust pipe. (Non-turbo model)
<Ref. to EX(w/oOBD)-9, REMOVAL, Front Exhaust
Pipe.> or <Ref. to EX-7, REMOVAL, Front Exhaust
Pipe.>
7) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-8, REMOVAL, Center Ex-
haust Pipe.>
AT-40
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
B3M1039A
H3M1839