Subaru 2002 IMPREZA Service Manual page 2116

ABS (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to ABS-10, SPECIAL TOOLS, PREPARA-
TION TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of instrument panel (on the driver's side).
(1) Data link connector
SUBARU SELECT MONITOR
S2M0285
S2M0286
(1)
BR0034
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and OBD-II general scan tool.
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(1) Power switch
6) On the «Main Menu» display screen, select the
{Each System Check} and press [YES] key.
7) On the «System Selection Menu» display
screen, select the {Brake Control System} and
press [YES] key.
8) Press the [YES] key after displayed information
of engine type.
9) On the «ABS Diagnosis» display screen, select
the {Diagnostic Code(s) Display} and press [YES]
key.
10) On the «Diagnostic Code(s) Display» display
screen, select the {Current Diagnostic Code(s)} or
{History Diagnostic Code(s)} and press [YES] key.
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For detailed concerning the DTC, refer to the
LIST OF DIAGNOSTICS TROUBLE CODE (DTC).
<Ref. to ABS-24, List of Diagnostics Trouble Code
(DTC).>
ABS-18
S2M0288D