DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12,15.
Usage Guideline
Use this command to enable the local proxy ARP function on an interface. This command is used in the
primary VLAN of a private VLAN domain to enable routing of packets among secondary VLANs or
isolated ports within the domain. The command only take effects when ip proxy arp is enabled.
Example
This example shows how to enable local proxy ARP on VLAN100.
Switch# configure terminal
Switch(config)# interface vlan100
switch(config-if)# ip local-proxy-arp
switch(config-if)#
8-7 ip mtu
This command is used to set the MTU value. Use the no form to revert to the default setting.
ip mtu BYTES
no ip mtu
Parameters
BYTES
Default
By default, the MTU value is 1500 bytes.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Some routing protocols, such as OSPF, will advertise this setting in the routing updates.
Example
This example shows how to set the IP MTU value as 6000 bytes for VLAN 4.
Switch# configure terminal
Switch(config)# interface vlan4
Switch(config-if) ip mtu 6000
Switch(config-if)# exit
Switch(config)#
8-8 show arp
This command is used to display the Address Resolution Protocol (ARP) cache.
Specifies to set the IP MTU value. The range is 512 to 16383 bytes.
123