Ipv6 Mtu - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if)#
9-7 ipv6 hop-limit
This command is used to configure the IPv6 hop limit on the switch. Use the no form of this command to
revert to the default setting.
ipv6 hop-limit VALUE
no ipv6 hop-limit
Parameters
VALUE
Default
The default value is 64.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the hop limit to be advertised in RA messages. The IPv6 packet
originated at the system will also use this value as the initial hop limit.
Example
This example shows how to configure the IPv6 hop limit value.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 hop-limit 255
Switch(config-if)#

9-8 ipv6 mtu

This command is used to configure the MTU value for IPv6. Use the no form to revert to the default
setting.
ipv6 mtu BYTES
no ipv6 mtu
Parameters
BYTES
Specifies the IPv6 hop limit range. Using the value 0 means to use the
default value to send packets. The valid range is 0 to 255.
Specifies to set the IPv6 MTU value. The range is 1280 to 65534
bytes.
133