Ipv6 Neighbor Settings - D-Link DAS-3626 User Manual

IPv6 Neighbor Settings

This window allows the user to create and configure IPv6 Neighbor settings on the switch. The switch's current IPv6
neighbor settings will be displayed in the table at the bottom of this window.
To view this window, click System Configuration > IPv6 Neighbor Settings as shown below:
The following parameters can be configured:
Parameter Description
Enter the interface name of the IPv6 neighbor you wish to configure.
Interface Name
Enter the neighbor IPv6 address of the entry you wish to configure.
Neighbor IPv6
Address
Enter the MAC address of the neighbor device to be added as an IPv6 neighbor on the IP
Link Layer MAC
interface.
Address
In order to search for a previously configured Interface name enter the appropriate information
Interface Name
and click Find. To remove a previously configured Interface enter the Interface name and click
Clear.
To find or delete specific entries use the pull down menu to select All, Address, Static, or
State
Dynamic.
All – Select All to view all configured neighbor devices which are IPv6 neighbors of the IP
interface previously created.
Address – Select Address and enter the IPv6 address of the entry you wish to find.
Static – Select Static to view all statically entered IPv6 neighbors on the switch.
Dynamic – Select Dynamic to view all dynamically configured neighbor devices which are IPv6
neighbors of the IP interface previously created.
Click Add to add a new entry, click Find to search for a specific entry or click Clear to remove an entry.
DAS-3626 VDSL2 Switch User Manual
Figure 18. IPv6 Neighbor Settings menu
17