Ipv6 Ospf Mtu-Ignore - D-Link DGS-6600-48TS Manual

DGS-6604

ipv6 ospf mtu-ignore

ipv6 ospf mtu-ignore [instance-id INSTANCE-ID]
no ipv6 ospf mtu-ignore [instance-id INSTANCE-ID]
Syntax Description
INSTANCE-ID
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 ospf mtu-ignore
CLI Reference Guide
To disable IPv6 Open Shortest Path First (OSPF) maximum transmission unit
(MTU) mismatch detection on receiving database descriptor (DBD) packets, use
the ipv6 ospf mtu-ignore command in interface configuration mode. To reset to
default, use the no form of this command.
(Optional) Instance identifier. If you want to change this ID, please configure "no"
command first. The range is from 0 to 255.
IPv6 OSPF MTU mismatch detection is enabled.
Interface configuration mode
IPv6 OSPF checks whether neighbors are using the same MTU on a common
interface. This check is performed when neighbors exchange DBD packets. If the
receiving MTU in the DBD packet is higher than the IP MTU configured on the
incoming interface, IPv6 OSPF adjacency will not be established.
The following example disables MTU mismatch detection on receiving DBD
packets..
ipv6 ospf mtu-ignore
361