Ip Ospf Message Digest Key Md5; Distance Ospf - Enterasys SECURESTACK C3 Configuration Manual

ip ospf message digest key md5

Example
This example shows how to enables an OSPF authentication key on the VLAN 1 interface with the
password "yourpass":
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip ospf authentication-key yourpass
ip ospf message digest key md5
Use this command to enable or disable OSPF MD5 authentication on an interface. This validates
OSPF MD5 routing updates between neighboring routers. The no form of this command disables
MD5 authentication on an interface.
Syntax
ip ospf message-digest-key keyid md5 key
no ip ospf message-digest-key keyid
Parameters
keyid
key
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to enable OSPF MD5 authentication on the VLAN 1 interface, set the key
identifier to 20, and set the password to "passone":
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip ospf message-digest-key 20 md5 passone

distance ospf

Use this command to configure the administrative distance for OSPF routes. The no form of this
command resets OSPF administrative distance to the default values.
Syntax
distance ospf {external | inter-area | intra-area} weight
no distance ospf {external | inter-area | intra-area}
20-20 IPv4 Routing Protocol Configuration
Specifies the key identifier on the interface where MD5 authentication is
enabled. Valid values are integers from 1 to 255.
Specifies a password for MD5 authentication to be used with the keyid. Valid
values are alphanumeric strings of up to 16 characters.
(su)‐>router(Config‐if(Vlan 1))#