Display Vlan-Ip Vlan - 3Com 8807 Command Reference Manual

IP Subnet-Based VLAN
Configuration
Commands

display vlan-ip vlan

mode: Specifies the VLAN based on other protocols.
The following protocols can be supported:
Protocol mode
Ethernet II-based VLAN
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
SNAP-based protocol
all: Supports all the protocols.
Description
Use the protocol-vlan command to specify the parameters of VLANs based on
AppleTalk, IPX, and so on.
Use the undo vlan-type protocol command to cancel this configuration.
Related command: display protocol-vlan vlan.
Example
# Specify VLAN 5 based on AppleTalk.
[3Com-vlan5] protocol-vlan at
Syntax
display vlan-ip vlan { vlan-list | all }
View
Any view
Parameter
vlan-list: Displays the information of a specified IP subnet-based VLAN, in the form
of vlan-list = { vlan-id [ to vlan-id ] }.
all: Displays the protocol information and indexes of all the IP subnet-based
VLANs.
IP Subnet-Based VLAN Configuration Commands
Parameter
ethernetii etype etype-id
llc dsap dsap-id ssap ssap-id
snap etype etype-id
87
Description
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
dsap-id: Indicates a
destination service access
point, in the range of 0 to FF
ssap-id: Indicates a source
service access point, in the
range of 0 to FF
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF