Aggregate - 3Com 8807 Command Reference Manual

40
n

aggregate

BGP/MPLS VPN C
C
OMMANDS
Refer to the 05-Routing Protocol Commands Module of the 3Com Switch 8800
Family Command Manual for the details about the if-match interface, if-match
acl, if-match ip-prefix, if-match ip next-hop, if-match cost, if-match tag,
apply ip next-hop, apply local-preference, apply origin, apply tag
commands and the related commands.
Syntax
aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
undo aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
View
VPN-instance sub-address family view
Parameter
address: IP address of an aggregated route, in dotted decimal notation.
mask: Network mask of an aggregated route, in dotted decimal notation.
as-set: Generates routes with AS sets.
detail-suppressed: Advertises only aggregated routes.
suppress-policy route-policy-name: Suppresses advertisement of some selected
specific routes.
origin-policy route-policy-name: Selects source route for aggregation.
attribute-policy route-policy-name: Sets the attributes of an aggregated route.
Description
Use the aggregate command to create an aggregation entry in the BGP routing
table of VPN instance.
Use the undo aggregate command to disable this function.
By default, route aggregation is not enabled.
ONFIGURATION