If-Match Cost; If-Match Interface - 3Com 8807 Command Reference Manual

558 C 28: IP R P C C
HAPTER OUTING OLICY ONFIGURATION OMMANDS
Related command: route-policy, ip community-list.
Example
# First define a community-list numbered 1, allowing it to contain the routing
information of AS 100 and AS 200. Then, define a route-policy named "test". An
if-match sub-statement is defined for Node 10 of the route-policy, which quotes
the definition of the community-list.
[SW8800] ip community-list 1 permit 100:200
[SW8800] route-policy test permit node 10
[3Com-route-policy] if-match community 1

if-match cost

Syntax
if-match cost value
undo if-match cost
View
Route policy view
Parameter
value: Specifies the required route metric value, ranging from 0 to 4294967295.
Description
Use the if-match cost command to configure one of the match rules of the
route-policy to match the cost of the routing information.
Use the undo if-match cost command to cancel the configuration of the match
rule.
By default, no if-match sub-statement is defined.
This is an if-match sub-statement of Route-policy, used to specify the cost of a
route matches the specified condition.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost, apply origin, apply tag.
Example
# Define an if-match sub-statement, allowing the routing information with routing
cost of 8 to pass this if-match sub-statement.
[3Com-route-policy] if-match cost 8

if-match interface

Syntax
if-match interface interface-type interface-number
undo if-match interface
View
Route policy view