Ip Netstream Timeout Inactive - 3Com 8807 Command Reference Manual

876 C 49: N C C
HAPTER ETSTREAM ONFIGURATION OMMANDS
Description
Use the ip netstream timeout active command to configure the active aging
time of the streams on all the NMM modules in the system.
Use the undo ip netstream timeout active command to restore the default
value of the active aging time of the streams on all the NMM modules in the
system.
By default, the active aging time of the stream is 30 minutes.
When the active time of a stream (from the set-up time to now) exceeds the set
limit, it will be aged.
Related command: ip netstream timeout inactive.
Example
# Set the active aging time of Netstream to 60 minutes.
<SW8800> system-view
[SW8800] ip netstream timeout active 60
ip netstream timeout Syntax
inactive
ip netstream timeout inactive seconds
undo ip netstream timeout inactive
View
System view
Parameter
seconds: Inactive aging time of Netstream in seconds.
Description
Use the ip netstream timeout inactive command to configure the inactive aging
time of Netstream.
Use the undo ip netstream timeout inactive command to restore the default
setting.
By default, the inactive aging time of Netstream is 60 seconds.
When the inactive time of a stream (from the time when the last packet of this
stream flows by to now) exceeds the set limit, it will be aged.
Related command: ip netstream timeout active.
Example
# Set the inactive aging time of Netstream to 150 seconds.
<SW8800> system-view
[SW8800] ip netstream timeout inactive 150