Vpn-Instance-Capability Simple - 3Com 8807 Command Reference Manual

n
vpn-instance-capability
simple
Use the undo vlan vpn-range command to restore the default MPLS label range
for the card.
After vpn-range is enabled on the card, the range of MPLS/VPN VLAN vlan-id that
can be configured on the 12 interfaces on the card is 4K, but not the default value
of 1K.
Related command: port trunk mpls vlan.
This command is actually effective for only the first 12 ports on the card. When
■
you configure MPLS/VPN VLAN vlan-id on subsequent ports, only the
MPLS/VPN VLAN range enabled for one VLAN will take effect. If you remove
MPLS/VPN configuration from an active port, no subsequent port will take
effect automatically either, and you have to reconfigure the ports to update
their states.
Restart the card after issuing a command or its corresponding undo command
■
to ensure that the configuration takes effect.
After the configuration on the card is canceled, if the VLAN configured on a
■
port exceeds 1K, which is the default value, the configuration will be deleted
automatically.
In aggregation mode, VPN-range configuration will not be synchronized
■
automatically and you can manually make/remove the configuration on an
individual port.
Example
# Configure the range of MPLS/VPN VLAN vlan-id on slot 5 as 4K.
<SW8800> system-view
[SW8800] vlan vpn-range slot 5 enable
Syntax

vpn-instance-capability simple

undo vpn-instance-capability
View
OSPF protocol view
Parameter
None
Description
Use the vpn-instance-capability simple command to configure a router as
Multi-VPN-Instance CE.
Use the undo vpn-instance-capability command to cancel the configuration.
OSPF multi-VPN-instance is often run at a PE router. Therefore, a CE router, on
which OSPF multi-VPN-instance runs, is called Multi-VPN-Instance CE. Though
LDP Configuration Commands 757