158
C
11: E
HAPTER
THERNET
link-aggregation group
agg-id mode
n
port link-aggregation
group
L
A
C
INK
GGREGATION
ONFIGURATION
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] link-aggregation group 22 description myal1
Syntax
link-aggregation group agg-id mode { manual | static }
undo link-aggregation group agg-id
View
System view
Parameter
agg-id: Aggregation group ID, in the range of 1 to 920. IDs 1 though 31 indicate
manual or static aggregation groups; IDs 32 through 64 are reserved; IDs 65
though 192 indicate Routed Trunks; IDs 193 through 920 indicate dynamic
aggregation groups.
Description
Use the link-aggregation group agg-id mode command to create an
aggregation group.
Use the undo link-aggregation group command to delete an aggregation
group.
Related command: display link-aggregation summary.
Port aggregation includes manual aggregation, static aggregation and dynamic
aggregation.
In the manual aggregation mode, ports working at different rates can be
■
aggregated. Manual aggregation can be load balancing aggregation if the
aggregation resource is available. In this case, if the traffic rate shared by a
low-rate port exceeds the maximum rate of the port, packets may be lost.
In the static aggregation mode, ports working at different rates can also be
■
aggregated. However, the Selected/Standby state of statically aggregated ports
is determined by the transmission rate. Only the ports with the maximum rate
and in full-duplex mode can be selected to forward traffic, while other standby
ports do not forward traffic.
Example
# Create manual aggregation group 22.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] link-aggregation group 22 mode manual
Syntax
port link-aggregation group agg-id
undo port link-aggregation group
C
OMMANDS