Timer Realtime-Accounting - 3Com 8807 Command Reference Manual

HWTACACS Configuration Commands 365
Parameter
minutes: Ranges from 1 to 255 minutes. By default, the primary server must wait
five minutes before it resumes the active state.
Description
Use the timer quiet command to set the waiting time before the primary server
resumes the active state.
Use the undo timer quiet command to restore the default configuration.
This command is designed to inhibit the switch from processing user request
packets for a time when the communication between the switch and the server is
interrupted. After the switch waits for a time that is equal or greater than the time
set by this command, it re-attempts to send packets to the server.
Related command: display hwtacac.
Example
# Set the quiet timer for the primary server to ten minutes.
[SW8800] hwtacacs scheme test1
[3Com-hwtacacs-test1] timer quiet 10
timer Syntax
realtime-accounting
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS view
Parameter
minutes: Real-time accounting interval, which is in the range of 3 to 60 minutes
and must be a multiple of 3. By defaults, it is 12 minutes.
Description
Use the timer realtime-accounting command to set the real-time accounting
interval.
Use the undo timer realtime-accounting command to restore the default
interval.
The setting of real-time accounting interval is necessary for real-time accounting.
After an interval is set, the NAS transmits the accounting information of online
users to the TACACS accounting server periodically.
The setting of real-time accounting interval somewhat depends on the
performance of the NAS and the TACACS server: a shorter interval requires higher
device performance. You are therefore recommended to adopt a longer interval
when there are a large number of users (more than 1000, inclusive). The following
table lists the numbers of users and the recommended intervals.