Display Vrrp Ifm - 3Com 8807 Command Reference Manual

790 C 43: VRRP C
HAPTER

display vrrp ifm

C
ONFIGURATION OMMANDS
Description
Use the display vrrp command to view the information about the VRRP state.
If the interface name and virtual router ID are not specified, the state information
about all the virtual routers on the switch will be displayed. If only the interface
name is specified, the state information about all the virtual routers on the
interface will be displayed. If the interface name and virtual router ID are specified,
the state information about the specified virtual router on the interface will be
displayed.
Example
# Display the VRRP state information on VLAN-interface 1.
[3Com-Vlan-interface1] display vrrp interface vlan-interface 1
Run Method : VIRTUAL-MAC
Virtual Ip Ping : Disable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Master IP
Table 100 Description on the fields of the display vrrp command
Field
Run Method
Virtual IP ping
Interface
VRID
Adver.Timer
Admin Status
State
Config Pri
Run Pri
Preempt Mode
Delay Time
Auth Type
Virtual IP
Master IP
Syntax
display vrrp ifm
View
Any view
: Vlan-interface1
: 1
: UP
: 100
: YES
: NONE
: Vlan-interface2
: 1.1.1.1
: 0.0.0.0
Description
Run method: real or virtual MAC method
Whether to enable to ping through virtual IP
Interface in which virtual router resides
ID of virtual router
Interval for sending vrrp packets
Control status of virtual router
Running state of virtual router
Configured priority
Run priority
Preempt mode
Delay time
Authentication type
Virtual IP address list of virtual router
IP address of the master device in virtual router
Adver. Timer : 1
State : Initialize
Run Pri : 90
Delay Time : 0
Pri Reduced : 10