Vrrp Ping-Enable - 3Com 8807 Command Reference Manual

VRRP Configuration Commands 795
View
System view
Parameter
real-mac: Uses the real MAC address of the interface to match the virtual IP
address of the virtual router in VRRP backup.
virtual-mac: Uses the virtual MAC address of the interface to match the virtual IP
address of the virtual router in VRRP backup.
Description
Use vrrp method command to set correspondence between the MAC address
and the virtual IP address of the virtual router: matching the real MAC address or
the virtual address with the virtual IP address.
Use the undo vrrp method command to reset the correspondence to the default
value.
By default, the switch matches the virtual MAC address with the IP address of the
virtual router.
Due to the chips installed, some switches support matching one IP address to
multiple MAC addresses. Then you may configure correspondence between the
virtual IP address of the virtual router and the real/virtual MAC address.
You should set correspondence between the IP address of the virtual router and
the MAC address before configuring the virtual router. Otherwise, you cannot
configure the correspondence.
If you set correspondence between the IP address of the virtual router and the real
MAC address, then you can configure only one virtual router on VLAN interface.
Example
# Set the real MAC address of the interface match the virtual IP address of the
virtual router.
[SW8800] vrrp method real-mac

vrrp ping-enable

Syntax
vrrp ping-enable
undo vrrp ping-enable
View
System view
Parameter
None
Description
Use vrrp ping-enable command to enable the function to ping the virtual IP
address of the virtual router.