Peer Enable - 3Com 8807 Command Reference Manual

MBGP Multicast Extension Configuration Commands 669
Description
Use the peer as-path-acl import command to configure filtering Policy of MBGP
received routes based on AS path list.
Use the undo peer as-path-acl import command to cancel the existing
configuration.
By default, the peer/peer group has no AS path list.
The inbound filter policy configured for the peer takes precedence over the
configurations for the peer group.
Related command: peer as-path-acl export, ip as-path-acl (refer to the
"Routing Protocol" part).
Example
# Set the AS path ACL of the peer group test to filter BGP received routes.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer test as-path-acl 3 import

peer enable

Syntax
peer group-name enable
undo peer group-name enable
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of the multicast peer group.
Description
Use the peer enable command to enable the MBGP peer group.
Use the undo peer enable command to disable the MBGP peer group.
By default, the MBGP peer group is disabled.
Only after the peer group is enabled, can the router establishes connection with
the multicast peer.
Example
# Enable peer group group1.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer group1 enable