Mpls Ldp Password - 3Com 8807 Command Reference Manual

mpls ldp password

Example
# First, configure the IP Prefix corresponding to the FEC address prefix.
<SW8800> system-view
[SW8800]ip ip-prefix fec1 index 1 permit 1.1.1.1 32
[SW8800]ip ip-prefix fec1 index 2 permit 1.1.1.2 32
# Then, configure the IP Prefix for the peer address used for advertisement.
<SW8800> system-view
[SW8800]ip ip-prefix peer1 index 1 permit
[SW8800]ip ip-prefix peer1 index 2 permit
[SW8800]ip ip-prefix fec2 index 1 permit 2.2.2.1 32
[SW8800]ip ip-prefix fec2 index 2 permit 2.2.2.2 32
[SW8800]ip ip-prefix peer2 index 1 permit
[SW8800]ip ip-prefix peer2 index 2 permit
# Apply the configured IP Prefix of FEC address and the configured IP Prefix of the
peer address in the filtering policy for outgoing label mapping advertisement.
<SW8800> system-view
[SW8800] mpls ldp label-advertise fec1 to peer1
# Configure to advertise the FEC message corresponding to FEC2 but not to create
Ingress LSP.
[SW8800] mpls ldp label-advertise fec2 to peer2 swap-only
Syntax
mpls ldp password [ cipher | simple ] password
undo mpls ldp password
View
VLAN interface view, remote-peer view
Parameter
cipher: Specifies that the password in configuration file will be displayed in
cipher-text.
simple: Specifies that the password in configuration file will be displayed in
plain-text.
password: User password.
Description
Use the mpls ldp password command to configure MD5 authentication
password for the LDP. After this configuration, the MD5 authentication is adopted
for LDP on the interface.
Use the undo mpls ldp password command to delete the configuration.
LDP Configuration Commands
2.1.1.1 32
2.1.1.2 32
4.1.1.1 32
4.1.1.2 32
701