Rip Work; Summary - 3Com 8807 Command Reference Manual

410 C 24: RIP C C
HAPTER ONFIGURATION OMMANDS
Example
# Configure the interface Vlan-interface 10 as RIP-2 broadcast mode.
[SW8800] interface Vlan-interface 10
[3Com-Vlan-interface10] rip version 2 broadcast

rip work

Syntax
rip work
undo rip work
View
Interface view
Parameter
None
Description
Use the rip work command to enable the running of RIP on an interface.
Use the undo rip work command to disable the running of RIP on an interface.
By default, RIP is running on an interface.
This command is used in cooperation with rip input, rip output and network
commands. Refer to the usage guideline of the related commands.
Related command: network, rip input, rip output.
Example
# Disable the interface Vlan-interface 10 to run the RIP.
[SW8800] interface Vlan-interface 10
[3Com-Vlan-interface10] undo rip work

summary

Syntax
summary
undo summary
View
RIP view
Parameter
None
Description
Use the summary command to configure to activate RIP-2 automatic route
summarization.
Use the undo summary command to disable RIP-2 automatic route
summarization.