Display Mpls L2Vc - 3Com 8807 Command Reference Manual

Martini MPLS L2VPN
Configuration
Commands

display mpls l2vc

out-label: Value of the out-label, ranging from 16 to 1,023.
Description
Use the static-lsp transit command to create a static L2VPN LSP for the midway
transmitting LSR.
Use the undo static-lsp transit command to remove the static L2VPN LSP created
for the midway transmitting LSR.
You need to create two LSPs (for transmitting and receiving) before creating a
remote CCC connection. You also need to enable the two LSPs to traverse
through each of the midway LSRs.
Related command: static-lsp egress l2vpn, static-lsp ingress l2vpn.
Example
# Create a static L2VPN LSP for the interface of VLAN 201 on the midway
transmitting LSR, with the in-label of 123 and the out-label of 253.
[3Com-mpls] static-lsp transit bj-sh l2vpn incoming-interface vlan-
interface 201 in-label 123 nexthop 202.34.114.7 out-label 253
Syntax
display mpls l2vc [ interface vlan-interface vlan-id | verbose ]
View
Any view
Parameter
vlan-id: ID of the VLAN whose interface is used to create the virtual circuit.
verbose: Displays the detailed information.
Description
Use the display mpls l2vc command to display the VC information of Martini
VLL.
Example
# Display detailed VC information.
<SW8800> display mpls l2vc verbose
Interface: Vlan-interface1000State: down, Encapsulation: ethernet,
Service: VLL
VC-ID: 4294967295, VC State: down, Destination: 3.3.3.3
Group ID: Local 0, Remote 0, VC Label: Local 32770, Remote 0,
Tunnel Type: LSP, Tunnel Index: 25
Martini MPLS L2VPN Configuration Commands 765