Portal Auth-Network; Portal Delete-User - 3Com 8807 Command Reference Manual

374 C 22: P C C
HAPTER ORTAL ONFIGURATION OMMANDS
If the user PC still does not respond after the sending times exceed the retry times,
the switch will regard the handshakes as abnormal, cut the connection with this
user actively and notify the Portal server about this case.
This command is ineffective for the Layer 3 Portal authentication method.
Example
# Set the interval of handshakes between the switch and the host to 120 seconds,
and set the maximum retry times to six times.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] portal arp-handshake interval 120 retry-times 6

portal auth-network

Syntax
portal auth-network network-address net-mask vlan vlan-id
undo portal auth-network { network-address net-mask | vlan vlan-id | all }
View
System view
Parameter
network-address net-mask: Address and subnet mask of the authentication
network section.
vlan-id: ID of the VLAN where the access port (where the authentication users
access into the switch across the network) lies in.
all: Disables all the configured authentication network sections.
Description
Use the portal auth-network command to configure the authentication network
section of a Portal client.
Use the undo portal auth-network command to disable the authentication
network section for a Portal client.
No authentications network section is configured by default.
This command is effective only for the Layer 3 Portal authentication method.
Example
# Configure the authentication network section for a Portal client:
192.168.0.200/16.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] portal auth-network 192.168.0.200 255.255.0.0 vlan 1

portal delete-user

Syntax
portal delete-user ip-address