Reset Mac-Address Vsi; Shutdown - 3Com 8807 Command Reference Manual

786 C 42: VPLS C C
HAPTER ONFIGURATION OMMANDS
Description
Use the pwsignal command to specify a PW signaling protocol for a VSI and enter
VSI-LDP view.
Specifying LDP as the PW signaling protocol for the VSI takes you to the VSI-LDP
view.
By default, the VSI uses LDP as the PW signaling protocol.
Example
# Set LDP as the PW signaling protocol for VSI 3Com and enter the VSI-LDP view.
<SW8800> system-view
[SW8800] vsi 3com static
[3Com-vsi-3com] pwsignal ldp

reset mac-address vsi

Syntax
reset mac-address vsi [ vsi-name [ peer peer-ip | vlan-interface vlan-num ] ] {
static | dynamic | all }
View
User view
Parameter
vsi-name: Refer to the configuration of related commands for VSI.
vlan-id: VLAN interface ID.
static: Specifies static MAC addresses.
dynamic: Specifies dynamic MAC addresses.
Description
Use the reset mac-address vsi command to batch remove VPLS MAC addresses.
The reset mac-address vsi command performs the same function as the undo
mac-address vsi command does.
Related command: undo mac-address vsi.
Example
# Remove all dynamic VPLS MAC addresses on Vlan-interface10 in VSI VPN1.
<SW8800> reset mac-address vsi vpn1 vlan-interface 10 dynamic

shutdown

Syntax
shutdown
undo shutdown
View
VSI view