Filter-Policy Export - 3Com 8807 Command Reference Manual

filter-policy export

Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
Table 53 Description of the fields of the display rip command
Field
RIP is running
public net VPN-Instance
Checkzero is on
Default cost : 1
Summary is on
Preference : 100
Traffic-share is off
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :202.38.168.0
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [
routing-protocol ]
View
RIP view
Parameter
acl-number: Access control list number used for filtering the destination addresses
of the routing information.
ip-prefix-name: Name of address prefix list used for filtering the destination
addresses of the routing information.
routing-protocol: Routing protocol whose routing information is to be filtered,
including direct, isis, bgp, ospf, ospf-ase, ospf-nssa and static at present.
Description
Use the filter-policy export command to configure to filter the advertised
routing information by RIP.
Use the undo filter-policy export command to configure not to filter the
advertised routing information.
By default, RIP does not filter the advertised routing information.
RIP Configuration Commands
Description
RIP is active
Public network in the VPN
Enable zero field checking
The default route cost is 1
Routes are summarized automatically
The preference of RIP is 100
Load balancing state for the interface
Three timers of RIP
No destination address of a transmission is
specified
Enable RIP on network segment 202.38.168.0
399