Dot1X Guest-Vlan - 3Com 8807 Command Reference Manual

298 C 20: 802.1 C C
HAPTER X ONFIGURATION OMMANDS
View
System view
Parameter
None
Description
Use the dot1x dhcp-launch command to set 802.1x to disable the switch to
trigger the user ID authentication over the users who configure static IP addresses
in DHCP environment.
Use the undo dot1x dhcp-launch command to set 802.1x to enable the switch
to trigger the authentication over them.
By default, the switch can trigger the user ID authentication over the users who
configure static IP addresses in DHCP environment.
Related command: dot1x.
Example
# Disable the switch to trigger the authentication over the users who configure
static IP addresses in DHCP environment.
[SW8800] dot1x dhcp-launch

dot1x guest-vlan

Syntax
dot1x guest-vlan vlan-id [ interface interface-list ]
undo dot1x guest-vlan vlan-id [ interface interface-list ]
View
System view, Ethernet interface view
Parameter
vlan-id: ID of the VLAN specified as the Guest VLAN. It ranges from 1 to 4094.
interface-list: List of Guest VLAN-enabled ports expressed in the format
interface-list =interface-type interface-number [ to interface-type
interface-number ] &<1-10>. interface-type means the interface type,
interface-number is the interface number. Refer to command parameters in the
"Port" section in the manual for the respective meanings and value ranges of
them. The interface number after the key word to should be no smaller than the
interface number before to. &<1-10> in the command means that the preceding
parameter can be entered up to 10 times.
Description
Use the dot1x guest-vlan command to enable Guest VLAN on a specific port.
Use the undo dot1x guest-vlan command to disable Guest VLAN.
If you execute the dot1x guest-vlan command in system view and do not provide
the interface-list argument, Guest VLAN is enabled on all ports. However, if you