Display Ospf Cumulative - 3Com 8807 Command Reference Manual

display ospf cumulative

Table 56 Description of the fields of the display ospf brief command
Field
Routing preference
Default ASE parameters
SPF computation count
Area Count
Nssa Area Count
SPF scheduled
Interface
Cost
State
Type
Priority
Designated Router
Backup Designated
Router
Timers
Transmit Delay
Syntax
display ospf [ process-id ] cumulative
View
Any view
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
Description
Use the display ospf cumulative command to view the OSPF cumulative
information.
Example
# Display the OSPF cumulative information.
<SW8800> display ospf cumulative
OSPF Process 1 with Router ID 1.1.1.1
Cumulations
IO Statistics
Type
Hello
DB Description
Routing preference of OSPF. The internal route of OSPF includes
intra/inter area route, and its default routing preference is 10.
While that of the external route of OSPF is 150 by default
Default ASE parameters of OSPF, including metric, type and tag
SPF computation count since OSPF is enabled
Areas for connection to this router
Number of NSSA areas
SPF scheduled (flag)
Interface name belonging to this area
Cost of routes
State information
Network type of OSPF interface
Priority
IP address of designated router (DR)
IP address of backup designated router (BDR)
OSPF timers, defining as follows:
Hello
Dead
Poll
Retransmit
Delay time of transmitting LSA
Input Output
225 437
78 86
OSPF Configuration Commands
Description
Interval of hello packet
Interval of dead neighbors
Interval of poll
Interval of retransmitting LSA
425