Mpls Ldp Transport-Ip - 3Com 8807 Command Reference Manual

LDP Configuration Commands 705
You can usually use the default values if not in special cases, Note that you must
reset the session to validate new values if you do modify these timer parameters.
Related command: mpls ldp and mpls ldp enable.
Example
# Modify the hold time of the Hello timer to 30 seconds.
<SW8800> system-view
[SW8800] interface vlan-interface 201
[3Com-Vlan-interface201] mpls ldp timer hello 30

mpls ldp transport-ip

Syntax
mpls ldp transport-ip { interface | ip-address }
undo mpls ldp transport-ip
View
VLAN interface
Parameter
interface: Sets the IP address of the current interface as the transport address.
ip-address: Sets the IP address as the transport address.
Description
Use the mpls ldp transport-ip command to configure an LDP transport address.
Use the undo mpls ldp transport-ip command to restore the default LDP
transport address.
By default, LSR ID is set as a transport address.
When there are multiple directly-connected and MPLS LDP-enabled links between
two LSR neighbors, all these links must be configured with the same transport
address (it is recommended to adopt the default LSR ID as the transport address).
Otherwise, the system may be unable to set up a steady LDP session.
For a Remote-peer, the transport address cannot be configured and is fixed to the
LSR ID.
By default, an LSR ID is the address of some Loopback interface and the Remote
peer can route to this address for a session. For a Local peer, the address of the
local interface or the Router ID of LSR can be adopted as its transport address.
Example
# Set the address of the current interface as a transport address.
<SW8800> system-view
[SW8800] interface vlan-interface 201
[Quidwa-Vlan-interface201] mpls ldp transport-ip interface
# Set the address of another interface as a transport address.