Display Jumboframe Configuration; Display Port - 3Com 8807 Command Reference Manual

134 C 10: E
HAPTER THERNET
display jumboframe
configuration

display port

P C C
ORT ONFIGURATION OMMANDS
Table 19 Description on the fields of the display interface command
Field
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input(normal): 0 packets, 0 bytes
- broadcasts, - multicasts
Input: 0 input errors, 0 runts, 0 giants, 0
throttles, 0 CRC
0 frame, 0 overruns, - aborts, 0 ignored, -
parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): 0 packets, 0 bytes
- broadcasts, - multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer
failures
0 aborts, 0 deferred, - collisions, 0 late
collisions
- lost carrier, - no carrier
Syntax

display jumboframe configuration

View
Any view
Parameter
None
Description
Use the display jumboframe configuration command to view the Jumbo frame
configuration on all cards. The supported Jumbo frame length ranges, as well as
the default values, may vary from card to card.
Example
# Display the current Jumboframe configuration in the system.
<SW8800>system-view
[SW8800] display jumboframe configuration
The jumboframe configuration at present:
Slot 2:
Allow jumbo frame to pass
The Maximum Frame Length is 1552
Syntax
display port { hybrid | trunk }
View
Any view
Description
The statistics information of input/output
packets and errors on this port. "-" indicates
that the item doesn't supported by the switch.