Reset Isis All; Reset Isis Peer - 3Com 8807 Command Reference Manual

Integrated IS-IS Configuration Commands 489
Several dynamic routing protocols could run simultaneously on a router. In this
case, there is an issue of sharing and selecting the routing information among all
the routing protocols. The system sets a preference for each routing protocol.
When various routing protocols find the route to the same destination, the
protocol with the higher preference will take effect.
Example
# Configure the preference of IS-IS as 25.
[3Com-isis] preference 25

reset isis all

Syntax
reset isis all
View
User view
Parameter
None
Description
Use the reset isis all command to reset all the IS-IS data structures.
By default, IS-IS data structure will not be cleared.
This command is used when LSPs need refreshing immediately. For example, after
the area-authentication-mode and domain-authentication-mode commands
are executed, the old LSP still remain on the router. This command can be used to
clear them.
Related command: area-authentication-mode,
domain-authentication-mode.
Example
# Reset all the IS-IS data structures.
<SW8800> reset isis all

reset isis peer

Syntax
reset isis peer system-id
View
User view
Parameter
system-id: Specifies the system ID of IS-IS neighbor.
Description
Use the reset isis peer command to reset the specified IS-IS peer.
By default, the IS-IS neighbor will not be cleared.