Portal Upload-Interface; Reset Portal - 3Com 8807 Command Reference Manual

Portal Configuration Commands 379

portal upload-interface

Example
portal upload-interface
undo portal upload-interface
View
Ethernet port view
Parameter
None
Description
Use the portal upload-interface command to enable the Portal rate limit
function on the upload interface.
Use the undo portal upload-interface command to disable the Portal rate limit
function.
By default, the Portal rate limit function is disabled.
The Portal rate limit function is used together with the bandwidth limit service that
the CAMS server provides. The bandwidth limit service is that you can specify the
bandwidth for each user when you are configuring the service for each user on
the CAMS server.
The principle of Portal rate limit is as follows: when the switch receives the
bandwidth limit rules for Portal users from the CAMS server, the switch will limit
the traffic on the upload interface where the portal upload-interface command
is executed, that is to say, the switch will perform bandwidth control for the
upload rates of Portal users. An upload interface is the interface to connect the
switch with the upstream network devices.
c
CAUTION: Only one upload interface for rate limit can be configured in one
system.
Example
# Configure Ethernet2/1/43 as the upload interface for Portal rate limit.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface Ethernet 2/1/48
[3Com-Ethernet2/1/43]portal upload-interface

reset portal

Syntax
reset portal { acm | server | tcp-cheat } statistics
View
User view
Parameter
acm: Clears the statistics about ACM, that is to say, clears the statistics about the
state machines related with authentication, connection and management.