Vrrp Log-State - 3Com 8807 Command Reference Manual

794 C 43: VRRP C C
HAPTER ONFIGURATION OMMANDS
If the simple or md5 authentication is configured, it is required to set the
authentication key.
This command is used to configure the authentication type and key for all the
VRRP virtual routers on an interface. As defined in the protocol, all the virtual
routers on an interface shall use the same authentication type and key. And all the
members joining the same virtual router shall also use the same authentication
type and key.
Note that the authentication key is case sensitive.
Example
# Specify the authentication type and key for a VRRP virtual router.
[3Com-vlan-interface2] vrrp authentication-mode simple 3com

vrrp log-state

Syntax
vrrp log-state
undo vrrp log-state
View
System view
Parameter
None
Description
Use the vrrp log-state command to enable debugging of state transition logs of
the VRRP virtual router.
Use the undo vrrp log-state command to disable debugging of state transition
logs of the VRRP virtual router.
Note that if you enable VRRP debugging after executing the vrrp log-state
command, the system does not output the state transition log of the VRRP virtual
router because the information is the same as the debugging information.
By default, debugging of state transition logs of the VRRP virtual router is disabled.
Example
# Enable debugging of VRRP state transition logs.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] vrrp log-state
vrrp method"vrrp Syntax
log-state"
vrrp method { real-mac | virtual-mac }
undo vrrp method