C-Rp - 3Com 8807 Command Reference Manual

PIM Configuration Commands 619
Related command: pim sm.
Example
# Configure the Ethernet switch as C-BSR with priority 2 (the C-BSR address is
designated as the IP address of VLAN-interface10 and the PIM SM protocol is
enabled on VLAN-interface 10).
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] multicast routing-enable
[SW8800] pim
[3Com-pim] c-bsr vlan-interface 10 24 2

c-rp

Syntax
c-rp interface-type interface-number [ group-policy acl-number | priority
priority-value ]*
undo c-rp { interface-type interface-number | all }
View
PIM view
Parameter
interface-type interface-number: Interface type and interface number, used to
specify the interface whose IP address is advertised as a candidate RP address.
acl-number: Number of the basic ACL that defines a group range, which is the
service range of the advertised RP. The value ranges from 2000 to 2999.
priority-value: Priority value of candidate RP, in the range of 0 to 255. By default, it
is 0. The greatest value corresponds to the lowest priority level
all: Removes all candidate RP configurations.
Description
Use the c-rp command to configure the router to advertise itself as a candidate RP.
Use the undo c-rp command to remove the configuration.
By default, no candidate RP is configured.
When configuring the candidate RP, a relatively large bandwidth should be
reserved for the router and other devices in the PIM domain.
Related command: c-bsr.
Example
# Configure the switch to advertise itself as a C-RP in the PIM domain to BSR. The
standard access list 2000 defines the groups related to the RP. The address of C-RP
is designated as the IP address of VLAN-interface10.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] acl number 2000