Speed; Stopbits - 3Com 8807 Command Reference Manual

Logging in to Switch Commands 61
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] user-interface vty 0 4
[3Com-ui-vty0-4] undo shell

speed

Syntax
speed speed-value
undo speed
View
User interface view
Parameter
speed-value: Specifies the transmission rate on the user interface in bps, which can
be 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200. The
default rate is 9600 bps.
Description
Use the speed command to configure the transmission rate on the user interface.
Use the undo speed command to restore the default rate.
This command can only be performed in Console and AUX user interface view.
Note that AUX user interface does not support the transmission rate: 57600 bps
and 115200 bps.
Example
# Configure the transmission speed on the AUX port as 4800 bps.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] user-interface aux 0
[3Com-ui-aux0] speed 4800

stopbits

Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
User interface view
Parameter
1: Sets 1 stop bit.
1.5: Sets 1.5 stop bits.
2: Sets 2 stop bits.